- 9mm Crown Cut Oak Veneered MDF
- MDF Cut to size in Chelmsford, Essex
- Delivery Nationwide
- Collection available from our workshop in Chelmsford, Essex
9mm Crown Cut Oak A/B 2 Sides Medium Density Fibreboard (MDF) 70% PEFC Certified.
Enter your Width and Height measurements above and we can cut your 9mm Crown Cut Oak Veneered MDF to size, Our minimum cutting size is Width 20mm and Length 50mm and there is a minimum area charge of 0.5m2. The maximum size will be dependant on the 9mm Crown Cut Oak Veneered MDF sheet size. Our online MDF cutting order form has been made to have the maximum sizes specified so there is no risk of you ordering a size that is not achievable.
Once you have selected your finish sizes you will also have the option to have your 9mm Crown Cut Oak Veneered MDF edged with matching pre-glued edging along with Finishing Spraying with Clear Lacquer. Please see our Spray Finish page to read about the paint we use along with our preparation procedures.
If your looking to buy a full sheet of 9mm Crown Cut Oak Veneered MDF. please go to our MDF Full Boards page which can be found in the Menu.
Our minimum lead times are:
MDF Cut To Size: 5-10 Working Days.
MDF Spray Finishing: 10-15 Working Days.
The Dartmoor range of veneered panels are produced to grading guidelines. These have been developed over time to give a superior grade of veneered board with maximum consistency.
On each species our manufacturers have taken a high grade of veneer from there supplier and further enhanced this by improving in the areas that are important to our customers, based on feedback from a number of different market sectors.
Whilst it is easy to measure certain criteria, such as the width of veneer leaves, our manufacturers are aware of the importance of the overall aesthetic appearance of the panel. Over a period of time, our manufacturers have enhanced the Dartmoor grade further still by ensuring that there manufacturers have a clear understanding of how important the appearance of a whole sheet is.
Consistency is a key factor – and to that end our manufacturers have ensured that there manufacturers produce a maximum number of veneers from each “flitch” and that boards are then clearly marked in batches. Only by doing this can we offer what our manufacturers believe to be the most consistent and highly graded commercial veneered board range available to the market today.
If you are to cut the MDF or Ply yourself, we would always recommend a competent person cuts the panel and the correct Personal Protective Equipment (PPE) should always be worn. There harmful fibres are known to cause health issues so goggles, dust mask, ear defenders and gloves should be worn. We would recommend a respirator with a P2 Filter rating should be considered compared to a disposable dust mask. It is also recommended that any cutting is undertaken in a well-ventilated area.